Hubei Acoustic Pipe factory direct supply Spot Wang: 15231769008 Wang: 15231769008 Wang: 15231769008 Wang: 15231769008 clamp compression acoustic tube, pile Acoustic Pipe, bridges acoustic tube, spiral pipe manufacturers Acoustic ** *** a, ultrasonic tube overview and content ultrasonic tube is the only specifically applied ultrasonic testing of a reliable system. After the basic concept is the use of specialized steel molding, use fasteners to connect and concrete impervious connection. Ultrasonic tube forming products usually include standard length of 9M, 6M, 3M pipe and a sealing gasket and a fastener. You can reserve a channel so that the probe head can reach the bottom pile. Second, the characteristics of a simple buckle connection, without site preparation work outside, without any equipment, simple and quick (five times faster than traditional methods), easily fixed in the steel cage, not bad weather two professional design , the factory 100% quality, cost-site detection convenient three saves preparation time, no mechanic, saving wear and tear (can be customized according to customer requirements of different types of short tube), subject to site constraints four quick, readily available in standard pipe within 24 hours to enter the site five security without welding work at three sites, site installation guidelines an ultrasonic tube (A) and the tube (B) or tube (C) attached to the steel cage, if necessary, install bottom to the ultrasound tube (A) at the bottom of the tube 2 the ultrasound (B) and aligned with the bottom of the tube (A) at the top. Ensure the two are in the same axis, positioning accuracy, extruded rubber seal is not deformed (Note: The ring can be self-positioning). 3 To ensure the installation fastening, with two wire (minimum diameter of 1.5mm) ultrasonic tube is connected to the upper and lower ends of the steel cage rack. The one end of a wire is connected to the tube (A) at the bottom of the positioning ear and the other end connected to a steel cage rack. The tubes were using fasteners (A) (B) (C) fixed together with wire attached to the steel cage, make sure that loose wire length is 10cm, so that you can move to the side or up and down the pipe. Connection: screw insertion Acoustic Pipe is the only exclusively used in ultrasonic testing of a reliable system. Is the use of chilled steel professional after forming, pressure clamp connection, screw connection, flange connection, etc. for connection, clamping connection, screw connection, flange connection reliable anti-seepage effect when concrete pouring. Acoustic Pipe typically includes the standard length of pipe has been formed and a connection 6M joint connection. You can reserve a channel so that the probe head can reach the bottom pile. Wang: 15231769008 Wang: 15231769008http: //www.cz-scg.net/product-16.html